Tipo de Pago: | L/C, T/T, Paypal, Western Union |
---|---|
Plazo de entrega: | 1 días |
Modelo: YP series
Breakdown content | Possible reasons | Removing methods |
No load condition, Motor not work |
Black out | Check power supply,ask electric power co., |
Connecting line break | Check wiring | |
Switch contact undesirable | Fix and change | |
Wire coil break | Sendprofessional motor factory repair |
|
Three-phase motor connect single phase voltage | Make sure voltage andmode of connection | |
Single-phase motor no connect capacitor | Connect a capacitor | |
Single-phase motor starter bad action | Sendprofessional motor factory repair |
|
Gear, axis and the bearing damage | Sendprofessional motor factory repair |
|
When load, Motor works |
Voltage below level | Check power line whether is too long or carefully |
Gears, weared | Sendprofessional motor factory repair |
|
Overload operate | Reduce load | |
Overload operate | Reduce load | |
Abnormal heating | Start, stop excessive | Reduce the frequency of use |
Bearingweared | Fix and change bearing | |
Deterioration of grease | Change oil | |
Voltage too high or too low | Make sure voltage whether is normal | |
Big noise | Loud and continuous: bearing damage, gear broken | Change bearing or gear |
Occasional loud: Gear injury, unusual thing got stuck | Pick up the unusual thing, and change gear | |
Abnormal unstable operating noise: Oil has been contaminated or insufficient oil | Check the oil color, concentration, oil level | |
Vibration is too large | Gears, bearing weared | Change the gear or bearing |
Fixed bad, loose bolts | Refasten it | |
Bottom of the fixed mounting rigidity bad | Increased rigidity of bottom | |
Oil leak:In the motor flange;In the motor oil seal;In the reducer flange;In the output part of the oil seal |
Loose bolts | Refasten it |
Ring damage | Change the seals | |
Leakage from air plug | Too much oil | Adjust the oil quantity |
Vent plug on incorrect | Assemble the air plug with right way | |
Frequent cold starts (oil foaming) or the oil level is too high | Change vent into the exhaust valve | |
Output sahft no work when motor works | Reducer shaft key connection damage | Send reducer factory repair |
Grupos de Producto : Equipo agitador / mezclador